Version: 3.1

Prerequisites for IBM Cloud Kubernetes Service

Environment Prerequisites

The minimum supported size for a Portworx cluster is three nodes. Each node must meet the following hardware, software, and network requirements:

Hardware
CPU	4 cores minimum, 8 cores recommended
RAM	4GB minimum, 8GB recommended
Disk `/var` `/opt`	2GB free 3GB free
Backing drive	8GB (minimum required) 128 GB (minimum recommended)
Operating system root partition	64 GB is the minimum required size for the root filesystem which contains the operating system 128 GB minimum recommended
Storage drives	Storage drives must be unmounted block storage: raw disks, drive partitions, LVM, or cloud block storage.
Network connectivity	Bandwidth: 10 Gbps recommended 1 Gbps minimum Latency requirements for synchronous replication: less than 10ms between nodes in the cluster
Node type	Bare metal and virtual machine (VM)

Software
Linux kernel and distro	Kernel version 3.10 or greater. To check if your Linux distro and kernel are supported, see Supported Kernels.
Docker	Version 1.13.1 or greater.
Key-value store	Portworx needs a key-value store to perform its operations. As such, install a clustered key-value database (`kvdb`) with a three node cluster. You can also use Internal KVDB during installation. In this mode, Portworx will create and manage an internal key-value store (KVDB) cluster. If you plan of using your own KVDB, refer to KVDB for Portworx for details on recommendations for installing and configuring a KVDB cluster.
Disable swap	Disable swap on all nodes that will run the Portworx software. Ensure that the swap device is not automatically mounted on server reboot.
Network Time Protocol (NTP)	All nodes in the cluster should be in sync with NTP time. Any time drift between nodes can cause unexpected behaviour, impacting services.

note

Portworx also requires the following ports:
- An open KVDB port. For example, if you're using etcd externally, open port 2379.
- An open UDP port at 9002.
For telemetry, open ports 9024, 12001, and 12002. Ensure you are running Portworx Operator version 23.7.0 or higher to configure the telemetry port:
- Portworx Versions 2.13.7 and Older: Open port 9024 specifically for telemetry.
- Portworx Versions 2.13.8 and Newer: Use port 9029 for telemetry.

Portworx ports for east to west traffic

Before you install Portworx on Kubernetes, ensure that you're using a supported Kubernetes version:

note

K3s users: You must use CSI integration to generate/use PVCs test2.

Supported Kubernetes Version
IKS: 1.26.15, 1.27.15, 1.28.11, 1.29.6, 1.30.2 (For IKS version 1.29.5 and above, Operator 23.10.4 or newer is required.)