Upgrade Portworx on DCOS
This guide walks through upgrading Portworx deployed on DCOS through the framework available in the DCOS catalog. If you are using a Portworx framework version older than 1.2*, refer [this guide to perform the Portworx upgrade.
Update the Portworx image from UI
The Portworx image to be used on each node is specified by the config variable
portworx image under
To upgrade to a newer version, you just need to update this field to the desired version. For example, if you want
to upgrade to v220.127.116.11 you would set this to
Update the Portworx image using DCOS CLI
If you want to update Portworx using the DCOS CLI instead of the UI, you can perform the following steps:
dcos portworx describe | \ jq '.node.portworx_image="portworx/px-enterprise:18.104.22.168"' > \ new-options.json dcos portworx update start --options=new-options.json
Now wait for the portworx install tasks to go to COMPLETE state on all the agents
dcos portworx --name=portworx update status deploy (serial strategy) (COMPLETE) └─ portworx-install (serial strategy) (COMPLETE) ├─ portworx-0:[install] (COMPLETE) ├─ portworx-1:[install] (COMPLETE) ├─ portworx-2:[install] (COMPLETE) ├─ portworx-3:[install] (COMPLETE) └─ portworx-4:[install] (COMPLETE)
At this point your Portworx cluster should be upgraded to the specified version.